pcb:drc
This is an old revision of the document!
This page will serve to document the design rule checker.
DRC Violations
- Line/arc/silk width is too thin
- Pin/via annular ring too small
- Pin/via drill size too small
- Pad too thin
- Silk lines in elements
- No paste
- Insufficient copper overlap
- Insufficient copper spacing
- Hole too close to line/pad/pin/via
- Hole touches arc
- Insufficient clearance inside polygon
Process
Presently, the violations are identified in find.c, and then appended to a list in either the lesstif or gtkhid.
pcb/drc.1533510261.txt.gz · Last modified: 2018/08/05 19:04 by cparker
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
